Description:
Used BRANDT KD-56 Edgebander (1997, installed in 2000)

!! Low hours - installed in 2000 !!

Description:
- automatic height adjustment with top pressure beam for all work stations
- equipped with digital height indicator for setting of upper beam.
- control panel located at machine infeed for easy operator access
- large coil table (800 mm diameter).
- automatic magazine for strip and coil feeding.
- hot melt granulate glue application system with 12 minute heat up time.
- strengthened precutter for 3mm pvc from coil.
- first pressure roller driven and one idle pressure roller
- double motor end trim unit for precision end trimming.
- top and bottom fine trimming unit equipped with digital counter for easy changeover.
tiltable from 0-15 degrees.
- includes scraping and buffing units.
- workpiece support roller extension to 350 mm (13 3/4").
- electronic frequency changer for all trimming motors, plus electronic motor braking
- electrical components according to UL/CSA listings.

Technical specifications:
Edgeband thickness -strips 0.4 - 3mm (0.016" - 1/8")max 3 x 45 mm
Coiled material 0.4 - 3mm (0.016" - 1/8")max 3 x 30 mm
Edgeband length strip material: 229 mm (9") min.
Panel length min. 140 mm (5-1/2")
Panel width min. 60 mm (2-3/8")
Panel thickness min. 8 mm (5/16") / max. 40mm (1-5/8")
Feed speed 9m/minute (30 fpm)
End trim unit - two motors 0.18 kw (.25hp each) 12,000 rpm
Flush trimming unit 0.27 kw (0.33 hp each) 12,000 rpm
Dust extraction outlet 100mm (4"), 800 cfm compressed
Air connection 6 bar (85 psi)
Total power required 3.8 kw 230/460/3 phase/60 hz
Total amperage 230 v. 16 amps - 460 v. 8 amps

Machine has been cleaned, checked under power, and is in very good condition. Includes rebuilt glue pot and new tooling. Feed chain removed, cleaned and lubed and half of the track pads were replaced with new, balance still good! New in 1997, but first installed in 2000 and well maintained by original owner in small repair shop - low hours!